How to Drill Into Concrete (Without Wrecking Your Bits)

Drilling concrete is easy with the right gear and a few good habits. Here's how to get clean holes and get the most life out of your masonry bits.

1. Use a rotary hammer, not a hammer drill

A cordless hammer drill will get through brick, but for concrete an SDS rotary hammer is far faster and much easier on you and the bit. The piston action does the work, so you don't need to lean on it.

2. Pick the right bit

Match the bit to the anchor (see our anchor sizing guide) and choose a length that reaches the depth you need plus around 10mm for dust. Tungsten carbide tips are a must for concrete.

3. Mark and start slow

Mark the spot, start in rotation-only or at low speed to stop the bit wandering, then switch to hammer mode once the tip has bitten in.

4. Let the hammer do the work

Use light, steady pressure. Pushing hard slows the hammer action, overheats the tip and is the number one reason bits wear out early.

5. Clear the dust

On deeper holes, pull the bit back out a few times to clear the flutes. Before setting an anchor, blow and brush the hole clean, especially for chemical anchors.

6. Hitting rebar

If the bit suddenly stops and you hear metal, you've probably hit reinforcing steel. Don't force it. Move the hole if the design allows, or switch to an SDS Max bit with a 4-cutter cross-head tip, which handles rebar better. Check with the engineer before cutting through structural steel.

7. Look after your bits

  • Don't let a hot bit sit in water to cool it, as it can crack the carbide
  • Replace bits once the tip is rounded, as worn bits drill undersized holes and anchors won't hold
  • Keep a spare of your most-used sizes on the ute. Our 5 and 10 packs are the cheapest way to do that

Safety

Wear eye and hearing protection, and use dust extraction or a P2 mask. Concrete dust contains crystalline silica, and Australian rules on silica dust are strict.

Shop SDS Plus and SDS Max masonry drill bits, shipped from Melbourne, free over $99.

Back to blog